Jk-audio BlueKeeper User Manual download pdf (Page 8)

Connection

Figure 3: Basic Connections

Although each application may require a slightly different setup, the

following diagram shows a primary configuration.

For a direct connection to BlueKeeper:

• Send Audio - Connect a dynamic microphone cable to the Send

1 jack on the BlueKeeper. Be sure to set the Mic/Line button to

the “Mic” position.

• Output - Connect a stereo cable from the mini-jack “Stereo Out”

on the BlueKeeper to the “Line In” on your computer sound card

or other recording equipment that has a stereo input, or connect

a mono cable from the mini-jack “Mono Out” on the BlueKeeper

to the “Mic In” on your laptop computer or other recording equip-

ment.

• Power - Connect the supplied DC power supply to the back of

the BlueKeeper and then to an AC power outlet.

• Your BlueKeeper is now ready to take calls. You can establish a

connection to your Bluetooth enabled cellular phone (see pages

16-17) and place or receive a call.

• Set the “Send” level control so that while you are speaking into

the mic, the Send LEDs on the BlueKeeper light the -20 dB green

LED consistently and flash the -9 dB green LED with only occa-

sional flashes on the -3 dB red LED. Set the “Caller” control for

good recording level of the caller audio at the output jack.

Set to

“Mic”

Mic

Sound Card

Computer

Line

out

Connect Stereo Out

to PC Line In or to

Stereo Line Input on

mini recorder

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Jk-audio BlueKeeper User Manual Page 8