Jk-audio Broadcast Host User Manual download pdf (Page 7)

Getting to Know Your Broadcast Host™

Getting to Know Your Broadcast Host

Indicators Cont’d

8. OH LED

Lit when you are on line with a call (Off-Hook).

9. Send LEDs

Displays the signal level going to the phone line. The goal is to drive the

phone line audio at levels high enough to avoid phone line noise, but

not so loud as to cause excessive clipping. Adjust the Send level control

so that you rarely see ashes of the red -3dB peak Send LED. These

ashes should occur only during loud speech bursts. If the red LED stays

lit for extended periods you can assume that much of your speech is

being clipped or distorted. In this case you should lower the Send volume

control for the input that is causing the clipping.

10. Power LEDs

Lit when unit is plugged in and receiving power.

11. Caller LEDs

Displays the signal level coming in from the phone line, after the DSP.

This signal level will not change when you adjust the Caller knob. The

Caller level control knob does not change what you see on these LEDs.

Adjust the Caller level control to give you the best signal level at the

Caller XLR output or the Caller channel of the stereo output mini jack.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Jk-audio Broadcast Host User Manual Page 7