User Guide RemoteMix 3 / 3.m Phone Line Hybrid and Telephone Handset Interface for Remote Broadcasts JK Audio
10 Your new JK Audio product has been registered with the Federal Communications Commission (FCC). This product complies with the standards in Part 68
11 be unplugged from the modular outlet until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer
RemoteMix 3 / 3.m is covered by a 2 year warranty to be free from defective workmanship and materials. In the event that the RemoteMix 3 / 3.m needs
2 to RJ-11 wall jack Tape recorder or audio equipment input or output, RCA or XLR Headphones or small speaker, 2 jacks 1/4” stereo or mono Microphones
3 1. Connect your audio equipment, microphone(s), and headphones to the input and output jacks on RemoteMix 3. 2. Connect the jack marked "Pho
4 VU Meter The VU meter shows the mix of both microphones and the tape signal going out over the phone line or handset interface. Send Side (To Phone
5 Handset Jack The handset jack on the right side of RemoteMix 3 / 3.m allows you to plug in a telephone handset and quickly set up a call before you
6 To test the batteries, simply press the Battery Test button on the front of the unit. If the LED lights, the batteries are still good. The unit may
7 Hybrid Null Adjustment (continued) The amount of transmit/receive isolation will depend on the quality of the telephone line. This circuit is factor
8 Inputs: Line: Connector RCA phono Jack Input Impedance 20 k ohms Level 250 mV RMS (-10 dBm nom.) Microphone: Connector Femal
9 FAQ’s ? The output from Mic 1 is very low but the other two mics are fine. ! Check the position of the Mic/Line switch near Mic 1. This first inp
Comments to this Manuals