Jk-audio PBXport User Manual download pdf (Page 6)

Operation

Connecting Cables

Although each application will require a slightly different

setup, standard configuration is as follows:

Handset cable - Connect the supplied RJ-22 handset cable

between the jack marked "Phone" on the front or back of

PBXport and to the handset jack on the base of your tele-

phone.

Handset - Connect your telephone handset to the RJ-22 jack

on the front or back of the PBXport marked "Handset". You

must keep a handset connected at all times, even when you

are not using it.

Send Audio - Connect a microphone directly or a mixing con-

sole mix-minus output to the Send jack on the PBXport. Be

sure to set the PBXport mic/line switch to the proper position

for your application. Mic = microphone connected directly,

Line = line level output from your audio equipment. More

about mix-minus on page 5.

Caller Audio - Connect the Caller Out jack to a line level input

on your mixing console or audio equipment.

Power - Connect the supplied AC power cable to the back of

the PBXport and then to an AC power outlet.

Your PBXport is now ready to take calls.

PBXport will disable the telephone handset microphone when

you press the Online button. Use your telephone to place or

screen a call. When you are ready to take the call on

PBXport, simply press the Online button. Make sure you do

not put the handset back in it's cradle while you are on a call.

This will still drop the call even though the handset itself is

disabled. If you need to take the call back on your telephone,

simply press the Handset button on PBXport. This will disable

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Jk-audio PBXport User Manual Page 6