PBXport Rackmount PBX Digital Hybrid JK Audio User Guide
10 FAQs ? Will PBX Port work with my __________ PBX phone system? ! Probably yes. We have to say probably because the handset interface is propriet
11 FAQs ? How do I connect a call through PBXport? Every time I press the “Online” button, the call is discon-nected. ! If you put the handset bac
12 Other Information Screw Terminal Block 1 - Speaker (+) Minimum 8 ohms, 1 watt max 2 - Speaker (-) Use together with terminal 1 3 - Ground 4 -
13 Inputs: Send Input: Female XLR 1 k ohm, 10 mV RMS nom. (-38 dBu nom.) Mic/Line pad switch Line = +5 dBu nom. Outputs: Caller Out: Mal
14 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limit
15 FCC Registration (continued) This can be found on the bottom of your telephone equipment, and, c) the ringer equivalence number (REN) for this e
Warranty PBXport is covered by a 2-year warranty to be free from defective workmanship and materials. In the event that the PBXport needs repair, you
2 Introduction PBXport will allow you to send and receive audio through your multi-line PBX, ISDN or analog telephone. While this may seem like a sim
3 1. Handset Button - Press this button to use the handset as on a normal phone call. 2. ON LED - Lit when you are online with a call using the digi
4 Features—Rear View 20 22 16 17 18 19 21 16. Caller Output - Male balanced XLR output contains caller au-dio from the far side of the call. 17.
5 Connection—Mix-Minus Setup Number of mics depends on mixer Caller to any line level input Aux Send to Send 1, Mic/Line button in (Line) Use Main Ou
6 Operation Connecting Cables Although each application will require a slightly different setup, standard configuration is as follows: Handset cable
7 Operation (continued) the Mix<Caller and Caller output on PBXport and connect your handset back to the telephone. Any audio sent into the Send in
8 Operation (continued) A-B-C Selector Switch Use this switch to select the correct type of handset micro-phone that your telephone uses. A=Electret,
9 Operation (continued) Optional Jumper Settings If your unit was purchased after December 2007, there are two jumpers located on the circuit board in
Comments to this Manuals